1) Features

• With solar energy, energy saving, no electrical wiring, installation everywhere and high security. Charge during the day and automatic ignition in the dark.

• A polycrystalline silicon solar panel laminated with FETs and a 18650 lithium battery are adopted with a long service life.

• By using intelligent control, high brightness in good weather and can also ensure a long duration of lighting in bad weather.

Convenient operation and flexible function with remote control.
2) SpecificationsSolar panel battery 5.5V / 640mA polycrystalline silicon battery 3.7V2200mAH * 2 lithiumLED high efficiency SMD white LED Max power: 600 mA * 4.2V = 2.52WABS shell material WeightControl Mode Light Power Control In conventional environments, the remote control distance is greater than 7 metersThe battery will be fully charged within 7 hours of direct sunlight (≥35000LUX). The maximum brightness at full power can last about 16 hours.
3) The installation

• Make sure the solar panel is installed in the area where there is enough sunlight to directly illuminate the solar panel. Solar panels hover from 1 to 2 o'clock at noon, the best sun steering facility. Intense sun

• Move the mechanical switch on the back of the solar panel to position "2" before installation.

• Shading the solar panel, press the button if the light can be on, if the function is normal, otherwise the internal storage battery may run out of power and the solar panel can be placed in the sun. To charge.

4) Function Set

• Remote control operation

Button function

• ON You can adjust the brightness, sync and other settings after pressing the On Day button and automatically turn on at night according to the settings you have made.

• OFF Power off: it does not turn on automatically at night after pressing this button 2H Press this button to set the time of the lights to 2 hours. 6H Press to set the light hours for 6 hours.+ 1H Press this button to add the lighting time, it is only effective if you press the 2H or 6H button.

• After pressing the 2H button, you can press this button to add the duration of lighting up to 10 hours, ie 12 hours in total, the first press with 1 flashing flash and the ten presses with 10 times blinking. By pressing.

• After pressing the 6H button, you can press this button to add the duration of lighting up to 6 hours, ie 12 hours in total, the first press with 1 flashing flash and the 6 presses with 6 flashes ; Press

• Brightness 3 levels of brightness to choose, 100%, 75%, 50%

• When the light is reduced to 0.5 seconds, the low light is closed, if the light is on, 0.5 seconds means that the brightness is low, Low brightness is activated, the timer ends at 1/4 of the time. brightness set until dawn. If you have not chosen the low brightness, the light will turn off automatically at the end of the time and will be turned back on. After dark the next day

• When the timing is finished, press the "ON" button to restore the highlighted operating status and restart the timing.

• The remote control is shown in the figure below.

5) Special reminder

• The light can be charged even when the power switch is set to OFF.

• Clean the solar panel regularly to make sure the sun is shining normally.

• Do not install the light in a dark or dark area as this will damage the battery if it is not charged for a long time.